The Value Cluster (Part 2): Software Installation
|
|
Posted by Kenneth Farmer, Tuesday November 08 2005 @ 04:14PM EST
|
|
ClusterMonkey: Get ready. Software will get installed, configuration files will get edited, nodes will boot, lights will blink, messages will get passed, and we will have a cluster. Joy.
If you are following along from part one of this series, you should be chomping at the bit to get some software on the cluster. Not to worry, in this installment will get those switch lights blinking. The entire cluster measures, 40 inches (102 cm) high, 24 inches (61 cm) wide, 18 inches (46 cm) deep and is shown in Figure One Below. (See part one for more and bigger pictures). It is also quite mobile (check out the wheels!). There is a single power cord and room on top of the rack to place a monitor and keyboard (only if needed). The DVD reader/burner can accommodate vertical loading as well.
Read more...
|
|
SpyderByte.com
SpyderByte.com
